Vitrex BT900SRIND Bedienungsanleitung PDF herunterladen (Seite 6)

- 6 -

cut material from around the blade area.

• Neverallowthediamondbladetorundry.Failuretokeepthewatertraytoppedup

will result in possible over-heating of the diamond.

• Donotexposetorain.

• Wearsuitableprotectiveequipment.

Eye Protection

shall be worn

Ear protection shall

be worn

Caution, risk of

cutting

Hand protection

shall be worn

• Adoptaworkingpositiontotheleftofthediamondblade.

• Ensurethatcutofftilepiecesarenotcaughtbythebladeandsentflying.

• Neverremoveloosesplinters,orchipswhilethediamondbladeismoving.

• Beforerepairingfaultsorremovingjammedtile,alwaysswitchthecutteroff

and un-plug.

• Beforeswitchingon,checkthatallspannersandsettingtoolshavebeenremoved.

• Whenleavingtheworkplace,switchoffthemotorandun-plug.

• Aftercarryingoutrepairormaintenanceworkallsafetyandsecurityfixturesmustbe

replaced immediately.

• Themanufacturer’ssafety,workingandmaintenanceinstructionsandthe

dimensions stated in the Technical Information must be adhered to.

• Therelevantregulationsforthepreventionofaccidentsandothergenerally

recognised safety regulations must be followed.

Caution! Switch off cutter immediately and un-plug if

- The power feed lead and switch are damaged

- The motor is overheating

- Smoke is emitted or there is a smell of charred insulating material

• Useonlydiamondbladeforwhichthemaximumpossiblespeedisnotlessthanthe

maximum spindle speed of the cutter and the material to be cut;

• Whentransportingthemachine,useonlytransportationdevicesanddoneveruse

guards for handling or transportation;

• Fillthecoolingtank3/4fullofwater.Itisquitenormalfortheequipmenttocause

splattering during use.

4 – SPECIAL SAFETY INSTRUCTIONS BEFORE

USING THE MACHINE

• Checkthefollowingpoints:

1. Does the voltage of the motor correspond to the mains voltage.

2. A grounded mains connection (wall socket) needs to be used.

3. Are the mains lead and the mains plug in a good condition without any loose ends

or damage.

• Avoidusinglongextensioncables.

• Alwaysplacethecuttingmachineonaflatsurfacetopreventinstability.

• Whileusingthemachine

1. Never use-cracked diamond blade, replace them.

2. Be sure that the switch is in the OFF-position before connecting the machine to the

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare

Vitrex BT900SRIND Bedienungsanleitung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Elektrowerkzeuge Vitrex BT900SRIND