Vitrex BT900SRIND Bedienungsanleitung PDF herunterladen (Seite 10)

- 10 -

Fig. 16 Fig. 17 Fig. 18

Fig. 19 Fig. 20 Fig. 21

Fig. 22

H. MAKING A 45˚ BEVEL CUT

1. Pull out the lock bar and raise up the cutting block. (Fig. 17).

2. Tilt the cutting block at 45˚ and tighten the lock knob (Fig. 18).

3. Following the same procedure as straight cut to cut the tile/stone. (Fig. 19)

I. MAKING A PLUNGE CUT

1. Pull out the lock bar and raise the cut unit. (Fig. 20)

2. Tighten the lock knob. (Fig. 21)

3. Following the same procedure as straight cut to cut the tile/stone. (Fig. 22)

J. REPLACING THE DIAMOND BLADE

NOTE: The Saw Blade should be checked before each use of the Stone/Tile Saw. A dull

or damaged Saw Blade is potentially dangerous to the operator and will result in a poor

quality stone/tile cut. Only use a continuous rim diamond blade.

WARNING!Disconnectthepowersupplybeforemakingadjustmentsormaintenanceon

the machine!

1. CHOICE OF THE DIAMOND Blade Only use diamond blades with diameter of 200mm.

The bore of the blade must be 22.23mm, rated at a minimum 3,000RPM.

1 2 ... 5 6 7 8 9 10 11 12

Keine Kommentare

Vitrex BT900SRIND Bedienungsanleitung Seite 10